U0448 — Invalid Data Received From Immobilizer Control Module
| Meaning | The engine computer has received implausible or corrupted data from the immobilizer control module over the vehicle's internal network. This means the modules are not communicating correctly with each other, affecting vehicle security and starting systems. |
| Family | Network (U) |
Typical symptoms
Security warning light stays illuminated on the dashboard
Some electrical accessories might act abnormally
Common causes
Weak vehicle battery causing low voltage during startup
Internal failure of the immobilizer control module
Communication bus wiring damage between modules
What to do
How to read code U0448
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code U0448 starts with U: it belongs to the network and communication between control units area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code U0448 mean?
Invalid Data Received From Immobilizer Control Module. The engine computer has received implausible or corrupted data from the immobilizer control module over the vehicle's internal network. This means the modules are not communicating correctly with each other, affecting vehicle security and starting systems.
Can I keep driving with code U0448 active?
With caution: limp mode possible, have it checked soon
Common causes — U0448
Poor connection or corrosion at the immobilizer module wiring harness Weak vehicle battery causing low voltage during startup Internal failure of the immobilizer control module Communication bus wiring damage between modules
How do you fix code U0448?
Check the condition and charge of your car battery first, as low voltage often triggers network communication errors. Inspect the wiring plugs near the ignition switch and immobilizer module for loose pins or moisture, and have a professional check the network lines if the issue persists.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: U0447 — Invalid Data Received From Immobilizer Control Mod...
- Next code: U0449 — Invalid Data Received From Immobilizer Control Mod...
Related codes
- U0400 — Invalid Data Received from Network
- U0401 — Invalid Data Received From Engine Control Module
- U0402 — Invalid Data Received From Transmission Control Module
- U0403 — U0403 – Invalid data from transfer case control module
- U0404 — U0404 – Invalid data from gear shift control module
- U0405 — U0405 – Invalid data from cruise control module
- U0406 — U0406 – Invalid data from fuel injector control module
- U0407 — U0407 – Invalid data from glow plug control module
- U0408 — U0408 – Invalid data from throttle actuator control module
- U0409 — U0409 – Invalid data from alternative fuel control module
- U040A — U040A – Invalid data from air conditioning control module
- U040B — U040B – Invalid data from EGR control module A