B1401 — Driver window one-touch relay circuit shorted to ground
| Meaning | The control module detected that the relay circuit for the driver's window automatic function is connected to ground when it should not be. B1401 is manufacturer-defined: I do not have reliable information on which component is involved on every brand. |
| Family | Body (B) |
Typical symptoms
Window not moving at all
Circuit fuse blown
Relay always on or never clicking
Door controls dead or intermittent
Common causes
Harness pinched or cut in the door passage
Faulty relay with an internal short
Connector with moisture pulling the signal to ground
Door module with a damaged output
Earlier repair with poorly insulated wires
What to do
How to read code B1401
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code B1401 starts with B: it belongs to the body (airbags, comfort, lights) area. It is defined by the manufacturer, so the exact meaning can change from make to make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code B1401 mean?
Driver window one-touch relay circuit shorted to ground. The control module detected that the relay circuit for the driver's window automatic function is connected to ground when it should not be. B1401 is manufacturer-defined: I do not have reliable information on which component is involved on every brand.
Can I keep driving with code B1401 active?
With caution: limp mode possible, have it checked soon
Common causes — B1401
Relay wire with worn insulation touching the sheet metal Harness pinched or cut in the door passage Faulty relay with an internal short Connector with moisture pulling the signal to ground Door module with a damaged output Earlier repair with poorly insulated wires
How do you fix code B1401?
Check the harness in the door passage for spots where the insulation touches the metal, then the relay and connectors. It will not stop the car, but a fuse that keeps blowing must be investigated, never replaced with a bigger one.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: B1400 — Driver window one-touch relay circuit shorted to b...
- Next code: B1402 — Driver window down switch circuit fault
Related codes
- B1400 — Driver window one-touch relay circuit shorted to battery
- B1402 — Driver window down switch circuit fault
- B1403 — Driver window up switch circuit fault
- B1404 — Driver window down circuit open
- B1405 — Driver window down circuit shorted to battery
- B1406 — Driver window down circuit shorted to ground
- B1407 — Driver window up circuit open
- B1408 — Driver window up circuit shorted to battery
- B1409 — Driver window up circuit shorted to ground
- B1410 — Driver window motor circuit fault
- B1411 — Driver window motor circuit open
- B1412 — Driver window motor circuit shorted to battery