Skip to content
Fault code dictionary (DTC)

B1408 — Driver window up circuit shorted to battery

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control module found battery voltage on the driver's window up circuit, where only the command signal should be. B1408 is manufacturer-defined; the precise cause varies by brand.
FamilyBody (B)

Typical symptoms

Driver window going up by itself or not stopping
Window not going down properly
Fuse blowing repeatedly
Motor getting hot or staying on
Door controls not responding
Battery going flat when parked

Common causes

Up wire with damaged insulation touching a live cable
Harness pinched in the door passage
Switch pack with water ingress
Wet connector creating electrical bridges
Door module with a shorted output
Switch contacts stuck

What to do

Check the harness and switch pack soon, since a short to positive can overheat wires. If the window moves by itself or the fuse blows, do not keep using the controls and have the car checked as a priority.

How to read code B1408

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code B1408 starts with B: it belongs to the body (airbags, comfort, lights) area. It is defined by the manufacturer, so the exact meaning can change from make to make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code B1408 mean?

Driver window up circuit shorted to battery. The control module found battery voltage on the driver's window up circuit, where only the command signal should be. B1408 is manufacturer-defined; the precise cause varies by brand.

Can I keep driving with code B1408 active?

With caution: limp mode possible, have it checked soon

Common causes — B1408

Up wire with damaged insulation touching a live cable Harness pinched in the door passage Switch pack with water ingress Wet connector creating electrical bridges Door module with a shorted output Switch contacts stuck

How do you fix code B1408?

Check the harness and switch pack soon, since a short to positive can overheat wires. If the window moves by itself or the fuse blows, do not keep using the controls and have the car checked as a priority.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes