Skip to content
Fault code dictionary (DTC)

B1440 — Wiper mode select switch circuit shorted to battery

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit sees battery voltage on a wiper mode select switch circuit where there should not be any. This code is manufacturer-defined and the exact meaning can differ between makes. The stalk signal is therefore corrupted.
FamilyBody (B)

Typical symptoms

Wipers start on their own
Wipers stuck in one mode
Stalk does not change the mode
Blown fuse in some cases

Common causes

Signal wire touching a live wire
Damaged insulation in the steering column wiring
Water in the connector
Internal switch short
Faulty body control module (rare)

What to do

Inspect the wiring and stalk connector for damaged insulation or moisture. If the wipers start by themselves, get it checked soon.

How to read code B1440

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code B1440 starts with B: it belongs to the body (airbags, comfort, lights) area. It is defined by the manufacturer, so the exact meaning can change from make to make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code B1440 mean?

Wiper mode select switch circuit shorted to battery. The control unit sees battery voltage on a wiper mode select switch circuit where there should not be any. This code is manufacturer-defined and the exact meaning can differ between makes. The stalk signal is therefore corrupted.

Can I keep driving with code B1440 active?

With caution: limp mode possible, have it checked soon

Common causes — B1440

Signal wire touching a live wire Damaged insulation in the steering column wiring Water in the connector Internal switch short Faulty body control module (rare)

How do you fix code B1440?

Inspect the wiring and stalk connector for damaged insulation or moisture. If the wipers start by themselves, get it checked soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes