Skip to content
Fault code dictionary (DTC)

B1464 — Seat belt switch circuit short to battery

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningCode B1464 is manufacturer-defined and I have no reliable information on how each brand uses it. The reference definition points to a short to battery positive in the seat belt switch circuit. The module reads too high a voltage on a wire that should sit at a specific level.
FamilyBody (B)

Typical symptoms

Belt warning stuck in the wrong state
Odd chime behaviour
Warning that does not change when buckling or unbuckling
Possible airbag light

Common causes

Switch wire touching a live cable
Damaged or wet connector under the seat
Buckle with an internal short
Wiring crushed by the seat rails
Module fault

What to do

Inspect the wiring under the seat, especially near the rails and connectors. Because it concerns a safety device, have it checked soon and keep wearing the belt.

How to read code B1464

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code B1464 starts with B: it belongs to the body (airbags, comfort, lights) area. It is defined by the manufacturer, so the exact meaning can change from make to make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code B1464 mean?

Seat belt switch circuit short to battery. Code B1464 is manufacturer-defined and I have no reliable information on how each brand uses it. The reference definition points to a short to battery positive in the seat belt switch circuit. The module reads too high a voltage on a wire that should sit at a specific level.

Can I keep driving with code B1464 active?

With caution: limp mode possible, have it checked soon

Common causes — B1464

Switch wire touching a live cable Damaged or wet connector under the seat Buckle with an internal short Wiring crushed by the seat rails Module fault

How do you fix code B1464?

Inspect the wiring under the seat, especially near the rails and connectors. Because it concerns a safety device, have it checked soon and keep wearing the belt.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes