142 — Exhaust Flap Activation
| Meaning | Exhaust Flap Activation. |
| System | DME 7.2 |
| Family | Manufacturer-native code |
How to read code 142
Code 142 is a native BMW code of the "DME 7.2" system: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code 142 mean?
Exhaust Flap Activation. (System: DME 7.2)
Can I keep driving with code 142 active?
With caution: limp mode possible, have it checked soon
How do you fix code 142?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usOther codes of the same control unit (DME 7.2)
- 1 — Leak Diagnosis Pump
- 10 — Lambda Sensor Pre Cat Bank 1 Signal
- 101 — Torque Monitoring
- 102 — Multifunction Steering Wheel Signal
- 103 — Control Unit Monitoring
- 104 — Clutch Switch Signal
- 105 — Control Unit Fault (RAM)
- 106 — Brake Switch Signal
- 107 — Control Unit Fault (ROM)
- 108 — Reset DME / Voltage Supply
- Previous code: 141 — Tank Fill Level Implausible
- Next code: 143 — Tank Ventilation or Tank Leakage (MS43)
Related codes
- 14 — Injection Phasing Sensor
- 14 — Valve Relay Fault
- 14 — Lambda Sensor Heater Post Cat Bank 1
- 14 — EGS/DME Connection Error
- 14 — Intake Air Temperature Sensor
- 140 — Map Cooling Thermostat Activation
- 140 — Tank Leak Pump Solenoid Reed Switch Open or Output Stage (MS...
- 141 — Electric Fan Activation
- 141 — Tank Fill Level Implausible
- 142 — Tank Leak Pump Solenoid Reed Switch Stuck Open or DMTL Modul...
- 143 — Tank Ventilation or Tank Leakage (MS43)
- 1430 — Boost Pressure or Actuator