1430 — Boost Pressure or Actuator
| Meaning | Boost Pressure or Actuator. |
| System | DDE 4 |
| Family | Manufacturer-native code |
How to read code 1430
Code 1430 is a native BMW code of the "DDE 4" system: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code 1430 mean?
Boost Pressure or Actuator. (System: DDE 4)
Can I keep driving with code 1430 active?
With caution: limp mode possible, have it checked soon
How do you fix code 1430?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usOther codes of the same control unit (DDE 4)
- 0100 — Air Flow Sensor HFM
- 0105 — Atmospheric Pressure Sensor
- 0110 — Intake Air Temperature Sensor
- 0115 — Coolant Temperature Sensor
- 0120 — Pedal Position Sensor 1
- 0190 — Rail Pressure Sensor
- 0200 — Injector Cylinder 1
- 0201 — Injector Cylinder 5
- 0202 — Injector Cylinder 3
- 0203 — Injector Cylinder 6
- Previous code: 143 — Tank Ventilation or Tank Leakage (MS43)
- Next code: 144 — Fuel System Large Leak Recognised
Related codes
- 14 — Injection Phasing Sensor
- 14 — Valve Relay Fault
- 14 — Lambda Sensor Heater Post Cat Bank 1
- 14 — EGS/DME Connection Error
- 14 — Intake Air Temperature Sensor
- 140 — Map Cooling Thermostat Activation
- 140 — Tank Leak Pump Solenoid Reed Switch Open or Output Stage (MS...
- 141 — Electric Fan Activation
- 141 — Tank Fill Level Implausible
- 142 — Exhaust Flap Activation
- 142 — Tank Leak Pump Solenoid Reed Switch Stuck Open or DMTL Modul...
- 143 — Tank Ventilation or Tank Leakage (MS43)