144 — Fuel System Large Leak Recognised
| Meaning | Fuel System Large Leak Recognised. |
| System | MS41 |
| Family | Manufacturer-native code |
How to read code 144
Code 144 is a native BMW code of the "MS41" system: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code 144 mean?
Fuel System Large Leak Recognised. (System: MS41)
Can I keep driving with code 144 active?
With caution: limp mode possible, have it checked soon
How do you fix code 144?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usOther codes of the same control unit (MS41)
- 1 — Ignition coil Cyl 2
- 10 — Coolant Temperature Sensor
- 100 — DME Control Unit SelfTest Failed
- 101 — Tyre Pressure Front Right
- 102 — Tyre Pressure Rear Right
- 103 — VANOS Error Inlet Camshaft
- 104 — VANOS Error Exhaust Camshaft
- 105 — VANOS Error Position Inlet Camshaft
- 106 — VANOS Error Position Exhaust Camshaft
- 107 — Electronic Throttle Self Test
- Previous code: 1430 — Boost Pressure or Actuator
- Next code: 145 — CAN chip in the ABS/ASC control unit
Related codes
- 14 — Injection Phasing Sensor
- 14 — Valve Relay Fault
- 14 — Lambda Sensor Heater Post Cat Bank 1
- 14 — EGS/DME Connection Error
- 14 — Intake Air Temperature Sensor
- 140 — Map Cooling Thermostat Activation
- 140 — Tank Leak Pump Solenoid Reed Switch Open or Output Stage (MS...
- 141 — Electric Fan Activation
- 141 — Tank Fill Level Implausible
- 142 — Exhaust Flap Activation
- 142 — Tank Leak Pump Solenoid Reed Switch Stuck Open or DMTL Modul...
- 143 — Tank Ventilation or Tank Leakage (MS43)