1079 — Supply voltage sensors 1
| Meaning | Supply voltage sensors 1. |
| System | CNG |
| Family | Manufacturer-native code |
How to read code 1079
Code 1079 is a native MAN code of the "CNG" system: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code 1079 mean?
Supply voltage sensors 1. (System: CNG)
Can I keep driving with code 1079 active?
With caution: limp mode possible, have it checked soon
How do you fix code 1079?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usOther codes of the same control unit (CNG)
- 1080 — Supply voltage sensors 2
- 132 — Air mass
- 1352 — Knock control cylinder 1
- 1353 — Knock control cylinder 2
- 1354 — Knock control cylinder 3
- 1355 — Knock control cylinder 4
- 1356 — Knock control cylinder 5
- 1357 — Knock control cylinder 6
- 173 — Exhaust temperature sensor
- 3011 — Heating probe before catalytic converter
Related codes
- 10 — Motor/door valve door 3 (rear)
- 10 — Engaged gear
- 100 — Oil pressure
- 1007 — Trip Drive Fuel Used (Natural Gas)
- 102 — Boost pressure
- 1031 — Trip Average Fuel Rate (Natural Gas)
- 1042 — ISO 11992 (trailer CAN): Data bus switched off
- 1043 — Supply voltage for peripherals
- 1045 — Gate interlock
- 105 — Charge air temperature
- 1056 — Trailer control module pressure control,
- 1057 — Central control unit - B-controller