3692 — recorded filtered temperature
| Meaning | recorded filtered temperature. |
| System | EDC |
| Family | Manufacturer-native code |
How to read code 3692
Code 3692 is a native MAN code of the "EDC" system: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code 3692 mean?
recorded filtered temperature. (System: EDC)
Can I keep driving with code 3692 active?
With caution: limp mode possible, have it checked soon
How do you fix code 3692?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usOther codes of the same control unit (EDC)
- 1079 — Supply to rail pressure sensor
- 1080 — Supply fuel supply pressure,
- 1131 — Charge air temperature ahead of engine
- 1231 — Engine CAN
- 173 — Exhaust temperature before particulate filter
- 3001 — Engine speed sensor, reverse polarity
- 3002 — Segment speed
- 3003 — Engine speed sensor/
- 3004 — EGR valve position
- 3005 — Timeout, message location 13
Related codes
- 36 — Door enable display door 2
- 3600 — System bus, general
- 3600 — No ignition - Too many unsuccessful start attempts
- 3600 — Fill level, clutch fluid
- 3601 — Output stage starter control
- 3601 — System bus, monitoring of the axle modulator drive axle
- 3601 — Front axle above technically permitted axle load
- 3601 — Overheating - Hardware threshold exceeded
- 3602 — System bus, monitoring of the axle modulator
- 3602 — Rear axle above technically permitted axle load
- 3602 — Overheating - Too many overheatings or
- 3602 — Reversing light relay