6203 — I-CAN fault: Aux_stat_ZBR_3 message
| Meaning | I-CAN fault: Aux_stat_ZBR_3 message. |
| System | ZBR2 |
| Family | Manufacturer-native code |
How to read code 6203
Code 6203 is a native MAN code of the "ZBR2" system: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code 6203 mean?
I-CAN fault: Aux_stat_ZBR_3 message. (System: ZBR2)
Can I keep driving with code 6203 active?
With caution: limp mode possible, have it checked soon
How do you fix code 6203?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usOther codes of the same control unit (ZBR2)
- 1007 — Trip Drive Fuel Used (Natural Gas)
- 1031 — Trip Average Fuel Rate (Natural Gas)
- 1676 — No 'Break light request' signal in ERC_RX (timeout)
- 2987 — Parameter record in central on-board computer 2
- 3000 — ZBR system
- 3001 — Wake up, computer
- 3102 — ZBR power supply
- 3103 — Analog ground
- 3104 — Analog ground
- 3107 — Ignition ON (relay tl. 15)
- Previous code: 6202 — I-CAN fault: Aux_stat_ZBR_2 message
- Next code: 6205 — I-CAN fault: Dash Display message could not be sen...
Related codes
- 62 — Limit switch CLOSED door 2 (front)
- 620 — Electrical power supply to steering angle sensors
- 6202 — I-CAN fault: Aux_stat_ZBR_2 message
- 6205 — I-CAN fault: Dash Display message could not be sent
- 6206 — T-CAN fault: ECAM1 message could not be sent
- 6207 — I-CAN fault: ECAM1 message could not be sent
- 6208 — I-CAN fault: DM1 ZBR2 message could not be sent
- 6209 — I-CAN fault: DM1 OBDU message could not be sent
- 6250 — no CAN message buffer
- 6251 — CAN message not evaluated
- 627 — Monitoring of voltage supply on PIN X1/16 - X1/17
- 627 — Voltage supply terminal 30