6304 — T-CAN warning level, temporary fault T-CAN
| Meaning | T-CAN warning level, temporary fault T-CAN. |
| System | ZBR2 |
| Family | Manufacturer-native code |
How to read code 6304
Code 6304 is a native MAN code of the "ZBR2" system: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code 6304 mean?
T-CAN warning level, temporary fault T-CAN. (System: ZBR2)
Can I keep driving with code 6304 active?
With caution: limp mode possible, have it checked soon
How do you fix code 6304?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usOther codes of the same control unit (ZBR2)
- 1007 — Trip Drive Fuel Used (Natural Gas)
- 1031 — Trip Average Fuel Rate (Natural Gas)
- 1676 — No 'Break light request' signal in ERC_RX (timeout)
- 2987 — Parameter record in central on-board computer 2
- 3000 — ZBR system
- 3001 — Wake up, computer
- 3102 — ZBR power supply
- 3103 — Analog ground
- 3104 — Analog ground
- 3107 — Ignition ON (relay tl. 15)
Related codes
- 63 — Limit switch CLOSED door 2 (rear)
- 6302 — Serial communication
- 6303 — T CAN ground
- 6305 — I-CAN warning level, temporary fault I-CAN
- 6320 — Status EBS (T-CAN) fault number
- 6321 — Status engine control (T-CAN) fault no.
- 6322 — Status gearbox (T-CAN) fault no.
- 6323 — Status MTS fault number
- 6324 — Status retarder (T-CAN) fault no.
- 6325 — Status ECAS (T-CAN) fault number
- 6326 — Status door 1 (K3-CAN) fault number
- 6327 — Status door 2 (K3-CAN) fault number