8108 — CAN message EDC: Cooling water temperature
| Meaning | CAN message EDC: Cooling water temperature. |
| System | INST |
| Family | Manufacturer-native code |
How to read code 8108
Code 8108 is a native MAN code of the "INST" system: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code 8108 mean?
CAN message EDC: Cooling water temperature. (System: INST)
Can I keep driving with code 8108 active?
With caution: limp mode possible, have it checked soon
How do you fix code 8108?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usOther codes of the same control unit (INST)
- 2987 — Parameter set in combination gauge or
- 8101 — Total failure of CAN messages
- 8103 — CAN message tachograph
- 8104 — CAN message tachograph: Route information
- 8105 — CAN message tachograph: Date / time
- 8106 — CAN message ECAM
- 8107 — CAN message central on-board computer
- 8109 — CAN message gearbox control unit
- 8110 — CAN message gearbox control unit: Display
- 8111 — CAN message EDC: Boost pressure
- Previous code: 8107 — Failure of Dash Display/Fuel Level message
- Next code: 8109 — CAN message gearbox control unit
Related codes
- 81 — Exhaust differential pressure
- 81 — Door sensor door 1 rear
- 8100 — Control unit defective; ROM checksum incorrect
- 8101 — Control unit defective; RAM fault
- 8101 — Total failure of CAN messages
- 8101 — Failure of all CAN messages, but no BUSOFF
- 8102 — Control unit defective; calibration data
- 8103 — Control unit defective; parameter data
- 8103 — CAN message tachograph
- 8103 — Failure of message TCO1 (speed, reset trip counter)
- 8104 — Pressure, pressure sensor – preliminary
- 8104 — CAN message tachograph: Route information