8381 — CAN data bus driveline, values in
| Meaning | CAN data bus driveline, values in. |
| System | ECAM |
| Family | Manufacturer-native code |
How to read code 8381
Code 8381 is a native MAN code of the "ECAM" system: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code 8381 mean?
CAN data bus driveline, values in. (System: ECAM)
Can I keep driving with code 8381 active?
With caution: limp mode possible, have it checked soon
How do you fix code 8381?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usOther codes of the same control unit (ECAM)
- 8010 — Pressure below warning level
- 8011 — Initial filling of circuit 1 – faulty
- 8012 — Initial filling of circuit 2 – faulty
- 8013 — Initial filling of circuit 3 – faulty
- 8014 — Initial filling of circuit 4 – faulty
- 8020 — No valid fault definition
- 8100 — Control unit defective; ROM checksum incorrect
- 8101 — Control unit defective; RAM fault
- 8102 — Control unit defective; calibration data
- 8103 — Control unit defective; parameter data
- Previous code: 8380 — CAN data bus driveline, receive time exceeded
- Next code: 8382 — CAN data bus driveline, values in
Related codes
- 83 — Door sensor door 2 rear
- 8310 — CAN data bus driveline, receive time overrun in
- 8320 — CAN data bus driveline, bus off
- 833 — Fuel Rack Position Sensor
- 8330 — CAN data bus driveline, receive time
- 8331 — CAN data bus driveline, values in 'TCO1
- 8340 — CAN data bus driveline, receive time exceeded
- 8341 — CAN data bus driveline, values in EBC1
- 835 — Oil level signal
- 8350 — CAN data bus driveline, receive time
- 8351 — CAN data bus driveline, value in
- 8360 — CAN data bus driveline, receive time