Skip to content
Fault code dictionary (DTC)

P021B — Cylinder 8 injection timing out of range

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected that injection in cylinder 8 happens at a different moment from the one requested. The code is standard, but how it is monitored varies by manufacturer. It appears on engines with at least 8 cylinders.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Jerky or noisy engine
Loss of power
Dark or white exhaust smoke
Unstable idle
Starting takes longer than normal

Common causes

Faulty or worn cylinder 8 injector
Wrong signal from the speed or phase sensors
Injector wiring or connector in poor condition
Irregular fuel supply pressure
Incorrect mechanical timing
Internal control unit fault

What to do

Have the cylinder 8 injector, its wiring and the crankshaft and camshaft sensor signals checked. If you notice knocking, smoke or marked roughness, do not keep using the car.

How to read code P021B

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P021B starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (1B) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P021B mean?

Cylinder 8 injection timing out of range. The control unit detected that injection in cylinder 8 happens at a different moment from the one requested. The code is standard, but how it is monitored varies by manufacturer. It appears on engines with at least 8 cylinders.

Can I keep driving with code P021B active?

With caution: limp mode possible, have it checked soon

Common causes — P021B

Faulty or worn cylinder 8 injector Wrong signal from the speed or phase sensors Injector wiring or connector in poor condition Irregular fuel supply pressure Incorrect mechanical timing Internal control unit fault

How do you fix code P021B?

Have the cylinder 8 injector, its wiring and the crankshaft and camshaft sensor signals checked. If you notice knocking, smoke or marked roughness, do not keep using the car.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes