Skip to content
Fault code dictionary (DTC)

P021C — Cylinder 9 injection timing out of range

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected that fuel is injected into cylinder 9 at a moment that does not match the one requested. The code is standard, but the details change with manufacturer and engine. It affects engines with at least 9 cylinders.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Uneven engine running
Loss of power
Abnormal exhaust smoke
Knocking or rough combustion noise
Starting difficulty

Common causes

Worn or faulty cylinder 9 injector
Incorrect signal from the speed or phase sensors
Damaged wiring or connector
Unstable fuel pressure
Mechanical timing problem
Control unit fault

What to do

Have the cylinder 9 injector checked, along with the speed and phase sensor signals and the wiring. If there is knocking or obvious smoke, stop and do not continue the trip.

How to read code P021C

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P021C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (1C) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P021C mean?

Cylinder 9 injection timing out of range. The control unit detected that fuel is injected into cylinder 9 at a moment that does not match the one requested. The code is standard, but the details change with manufacturer and engine. It affects engines with at least 9 cylinders.

Can I keep driving with code P021C active?

With caution: limp mode possible, have it checked soon

Common causes — P021C

Worn or faulty cylinder 9 injector Incorrect signal from the speed or phase sensors Damaged wiring or connector Unstable fuel pressure Mechanical timing problem Control unit fault

How do you fix code P021C?

Have the cylinder 9 injector checked, along with the speed and phase sensor signals and the wiring. If there is knocking or obvious smoke, stop and do not continue the trip.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes