P0223 — Throttle/pedal position sensor B circuit high input
| Meaning | The control unit is receiving a voltage from pedal or throttle sensor B that is higher than the expected maximum. It can come from a short to the power supply, a missing ground or a faulty sensor. Which sensor counts as B depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Engine in limp mode
Engine speed staying high or not responding to the pedal
Uneven idle
Limited power
Unpredictable acceleration
Common causes
Broken or faulty sensor ground
Damaged or corroded connector
Faulty pedal or throttle sensor
Throttle body internal fault
Faulty control unit
What to do
How to read code P0223
This is a serious fault: driving behaviour may get worse or other components may be damaged if the vehicle is used without checking it.
The code P0223 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (23) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0223 mean?
Throttle/pedal position sensor B circuit high input. The control unit is receiving a voltage from pedal or throttle sensor B that is higher than the expected maximum. It can come from a short to the power supply, a missing ground or a faulty sensor. Which sensor counts as B depends on the manufacturer.
Can I keep driving with code P0223 active?
With caution: limp mode possible, have it checked soon
Common causes — P0223
Sensor wire shorted to the power supply Broken or faulty sensor ground Damaged or corroded connector Faulty pedal or throttle sensor Throttle body internal fault Faulty control unit
How do you fix code P0223?
Check the sensor ground, the connector and the wiring. If the engine speed stays high or the car accelerates unexpectedly, stop safely and have it checked before driving again.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0222 — Throttle/pedal position sensor B circuit low input
- Next code: P0224 — Throttle/pedal position sensor B circuit intermitt...
Related codes
- P0200 — Injector circuit: general electrical fault
- P0201 — Injector cylinder 1: circuit
- P0202 — Injector circuit cylinder 2: electrical fault
- P0203 — Injector circuit cylinder 3: electrical fault
- P0204 — Injector circuit cylinder 4: electrical fault
- P0205 — Injector circuit cylinder 5: electrical fault
- P0206 — Injector circuit cylinder 6: electrical fault
- P0207 — Injector circuit cylinder 7: electrical fault
- P0208 — Injector circuit cylinder 8: electrical fault
- P0209 — Injector circuit cylinder 9: electrical fault
- P020A — Injector 1: performance out of range
- P020B — Injector 2: performance out of range