P0224 — Throttle/pedal position sensor B circuit intermittent
| Meaning | The control unit detected that the signal from pedal or throttle sensor B comes and goes, or jumps, for no reason related to driving. This kind of fault is often down to contacts or wiring that only work some of the time. Which sensor counts as B depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Sudden, short loss of power
Jerking under acceleration
Idle that hunts
Limp mode that comes and goes
Problem getting worse over bumps or vibration
Common causes
Partly broken wire in the harness
Worn pedal or throttle sensor
Wiring that rubs or is under tension
Moisture in the connector
Faulty control unit
What to do
How to read code P0224
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0224 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (24) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0224 mean?
Throttle/pedal position sensor B circuit intermittent. The control unit detected that the signal from pedal or throttle sensor B comes and goes, or jumps, for no reason related to driving. This kind of fault is often down to contacts or wiring that only work some of the time. Which sensor counts as B depends on the manufacturer.
Can I keep driving with code P0224 active?
With caution: limp mode possible, have it checked soon
Common causes — P0224
Connector with a weak or corroded contact Partly broken wire in the harness Worn pedal or throttle sensor Wiring that rubs or is under tension Moisture in the connector Faulty control unit
How do you fix code P0224?
Gently move the connector and wiring with the engine running to see whether the symptom appears: it helps find the weak contact. Since power can be lost suddenly, this is not a fault to put off.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0223 — Throttle/pedal position sensor B circuit high inpu...
- Next code: P0225 — Throttle/pedal position sensor C circuit fault
Related codes
- P0200 — Injector circuit: general electrical fault
- P0201 — Injector cylinder 1: circuit
- P0202 — Injector circuit cylinder 2: electrical fault
- P0203 — Injector circuit cylinder 3: electrical fault
- P0204 — Injector circuit cylinder 4: electrical fault
- P0205 — Injector circuit cylinder 5: electrical fault
- P0206 — Injector circuit cylinder 6: electrical fault
- P0207 — Injector circuit cylinder 7: electrical fault
- P0208 — Injector circuit cylinder 8: electrical fault
- P0209 — Injector circuit cylinder 9: electrical fault
- P020A — Injector 1: performance out of range
- P020B — Injector 2: performance out of range