Skip to content
Fault code dictionary (DTC)

P023C — Charge Air Cooler Coolant Pump A: Control High

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe engine computer detected a voltage that is too high on control A of the water-cooled intercooler coolant pump, typical of a short to supply voltage or a driver fault. The pump may stay on or fail to respond to commands. The meaning of "A" depends on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Pump that always runs or never runs
Intake air temperature out of range
Loss of performance
Possible flat battery if the pump stays on

Common causes

Control wire shorted to supply voltage
Pump relay stuck
Faulty coolant pump
Damaged connector with pins touching
Faulty engine computer (rare)

What to do

Check the relay, wiring and connector of the pump, and see whether it keeps running with the engine off. It is not usually an emergency, but if the pump stays on the battery can go flat, so have it done soon.

How to read code P023C

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P023C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (3C) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P023C mean?

Charge Air Cooler Coolant Pump A: Control High. The engine computer detected a voltage that is too high on control A of the water-cooled intercooler coolant pump, typical of a short to supply voltage or a driver fault. The pump may stay on or fail to respond to commands. The meaning of "A" depends on the manufacturer.

Can I keep driving with code P023C active?

With caution: limp mode possible, have it checked soon

Common causes — P023C

Control wire shorted to supply voltage Pump relay stuck Faulty coolant pump Damaged connector with pins touching Faulty engine computer (rare)

How do you fix code P023C?

Check the relay, wiring and connector of the pump, and see whether it keeps running with the engine off. It is not usually an emergency, but if the pump stays on the battery can go flat, so have it done soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes