P023D — Boost sensor A and MAP sensor readings do not agree
| Meaning | The control unit compares the pressure from boost sensor A with the one from the manifold pressure (MAP) sensor. The two should read about the same, but they differ by more than the allowed amount. The code does not say which sensor is wrong: it can be a sensor, but also an air leak or blockage between the two measuring points. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power or sluggish throttle response
Engine may go into reduced-power (limp) mode
Whistling or hissing under acceleration if air is leaking
Black smoke or higher fuel use than usual
Common causes
Dirty or out-of-calibration MAP sensor or boost sensor A
Blocked or disconnected sensor pressure port or small hose
Corroded connector or wiring with poor contact
Leaking intercooler or its connections
What to do
How to read code P023D
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P023D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (3D) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P023D mean?
Boost sensor A and MAP sensor readings do not agree. The control unit compares the pressure from boost sensor A with the one from the manifold pressure (MAP) sensor. The two should read about the same, but they differ by more than the allowed amount. The code does not say which sensor is wrong: it can be a sensor, but also an air leak or blockage between the two measuring points.
Can I keep driving with code P023D active?
With caution: limp mode possible, have it checked soon
Common causes — P023D
Cracked or loose boost pipe or hose Dirty or out-of-calibration MAP sensor or boost sensor A Blocked or disconnected sensor pressure port or small hose Corroded connector or wiring with poor contact Leaking intercooler or its connections
How do you fix code P023D?
First look over all the hoses and clamps in the intake air circuit, then check the condition of both sensor connectors. You can drive carefully for short distances, but if the car loses a lot of power or goes into protection mode, have the live readings of both sensors checked to find out which one is off.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P023C — Charge Air Cooler Coolant Pump A: Control High
- Next code: P023E — Boost sensor B and MAP sensor readings do not agre...
Related codes
- P0200 — Injector circuit: general electrical fault
- P0201 — Injector cylinder 1: circuit
- P0202 — Injector circuit cylinder 2: electrical fault
- P0203 — Injector circuit cylinder 3: electrical fault
- P0204 — Injector circuit cylinder 4: electrical fault
- P0205 — Injector circuit cylinder 5: electrical fault
- P0206 — Injector circuit cylinder 6: electrical fault
- P0207 — Injector circuit cylinder 7: electrical fault
- P0208 — Injector circuit cylinder 8: electrical fault
- P0209 — Injector circuit cylinder 9: electrical fault
- P020A — Injector 1: performance out of range
- P020B — Injector 2: performance out of range