P023F — Fuel pump secondary circuit open
| Meaning | The control unit has detected an open (broken) connection in the secondary control circuit of the fuel pump. The exact meaning, such as which pump or which part of the circuit, can vary between manufacturers, and I have no reliable details to be more specific for every make. In general it means the electrical connection of that section is not completing properly. |
| Family | Powertrain (P) |
Typical symptoms
Hard starting or no start
Sudden stalling or jerking while driving
Loss of power, especially under load
Rough running when cold or hot
Common causes
Faulty pump fuse or relay
Failed fuel pump or its control module
Poor electrical ground
Faulty pump control unit (rare)
What to do
How to read code P023F
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P023F starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (3F) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P023F mean?
Fuel pump secondary circuit open. The control unit has detected an open (broken) connection in the secondary control circuit of the fuel pump. The exact meaning, such as which pump or which part of the circuit, can vary between manufacturers, and I have no reliable details to be more specific for every make. In general it means the electrical connection of that section is not completing properly.
Can I keep driving with code P023F active?
With caution: limp mode possible, have it checked soon
Common causes — P023F
Broken, corroded or loose pump connector or wiring Faulty pump fuse or relay Failed fuel pump or its control module Poor electrical ground Faulty pump control unit (rare)
How do you fix code P023F?
Check the pump fuses, relays and connectors first. The risk is being stranded with a car that will not restart, so have it checked soon at a workshop and avoid repeated start attempts.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P023E — Boost sensor B and MAP sensor readings do not agre...
- Next code: P0240 — Boost sensor B signal out of expected range
Related codes
- P0200 — Injector circuit: general electrical fault
- P0201 — Injector cylinder 1: circuit
- P0202 — Injector circuit cylinder 2: electrical fault
- P0203 — Injector circuit cylinder 3: electrical fault
- P0204 — Injector circuit cylinder 4: electrical fault
- P0205 — Injector circuit cylinder 5: electrical fault
- P0206 — Injector circuit cylinder 6: electrical fault
- P0207 — Injector circuit cylinder 7: electrical fault
- P0208 — Injector circuit cylinder 8: electrical fault
- P0209 — Injector circuit cylinder 9: electrical fault
- P020A — Injector 1: performance out of range
- P020B — Injector 2: performance out of range