Skip to content
Fault code dictionary (DTC)

P023E — Boost sensor B and MAP sensor readings do not agree

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit compares the pressure from boost sensor B with the one from the MAP sensor. In normal conditions they should match, but they differ too much. Sensor B is the second sensor in the system (for example on a second turbo or second stage); the code alone does not tell which reading is wrong.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Loss of power, especially under load
Slow response when pressing the accelerator
Possible protection mode with limited power
Hissing or air noises under acceleration

Common causes

Leaking hose, pipe or clamp in the boost circuit
Dirty or faulty sensor B or MAP sensor
Blocked or disconnected sensor pressure port or small hose
Damaged or corroded sensor wiring or connector
Leak at the intercooler or intake manifold

What to do

Inspect the air pipes and sensor connectors, starting with those closest to sensor B. If power drops a lot, avoid long periods under load and have the real pressures checked with a diagnostic tool.

How to read code P023E

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P023E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (3E) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P023E mean?

Boost sensor B and MAP sensor readings do not agree. The control unit compares the pressure from boost sensor B with the one from the MAP sensor. In normal conditions they should match, but they differ too much. Sensor B is the second sensor in the system (for example on a second turbo or second stage); the code alone does not tell which reading is wrong.

Can I keep driving with code P023E active?

With caution: limp mode possible, have it checked soon

Common causes — P023E

Leaking hose, pipe or clamp in the boost circuit Dirty or faulty sensor B or MAP sensor Blocked or disconnected sensor pressure port or small hose Damaged or corroded sensor wiring or connector Leak at the intercooler or intake manifold

How do you fix code P023E?

Inspect the air pipes and sensor connectors, starting with those closest to sensor B. If power drops a lot, avoid long periods under load and have the real pressures checked with a diagnostic tool.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes