P0241 — Boost sensor B signal too low
| Meaning | The signal voltage from boost sensor B is below the minimum allowed. The control unit reads this as an electrical fault in the circuit, such as a wire shorted to ground or a missing supply, or a failed sensor. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power
Protection mode with limited boost
Weak throttle response
Higher fuel use than normal
Common causes
Missing or broken 5-volt supply to the sensor
Failed boost sensor B
Wet, corroded or damaged connector
Faulty control unit (rare)
What to do
How to read code P0241
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0241 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (41) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0241 mean?
Boost sensor B signal too low. The signal voltage from boost sensor B is below the minimum allowed. The control unit reads this as an electrical fault in the circuit, such as a wire shorted to ground or a missing supply, or a failed sensor.
Can I keep driving with code P0241 active?
With caution: limp mode possible, have it checked soon
Common causes — P0241
Sensor wiring shorted to ground Missing or broken 5-volt supply to the sensor Failed boost sensor B Wet, corroded or damaged connector Faulty control unit (rare)
How do you fix code P0241?
Inspect the sensor B connector and wires for chafing or moisture. You can drive carefully for a short time, but the control unit limits power, so it is better to have the circuit checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0240 — Boost sensor B signal out of expected range
- Next code: P0242 — Boost sensor B signal too high
Related codes
- P0200 — Injector circuit: general electrical fault
- P0201 — Injector cylinder 1: circuit
- P0202 — Injector circuit cylinder 2: electrical fault
- P0203 — Injector circuit cylinder 3: electrical fault
- P0204 — Injector circuit cylinder 4: electrical fault
- P0205 — Injector circuit cylinder 5: electrical fault
- P0206 — Injector circuit cylinder 6: electrical fault
- P0207 — Injector circuit cylinder 7: electrical fault
- P0208 — Injector circuit cylinder 8: electrical fault
- P0209 — Injector circuit cylinder 9: electrical fault
- P020A — Injector 1: performance out of range
- P020B — Injector 2: performance out of range