P0242 — Boost sensor B signal too high
| Meaning | The signal voltage from boost sensor B is above the maximum allowed. The control unit treats this as an electrical fault: a wire shorted to the supply, a broken sensor ground, or a faulty sensor. |
| Family | Powertrain (P) |
Typical symptoms
Limited or uneven power
Protection mode
Abnormal throttle response
Unusual smoke or fuel use
Common causes
Broken or poor sensor ground
Failed boost sensor B
Damaged or corroded connector
Faulty control unit (rare)
What to do
How to read code P0242
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0242 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (42) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0242 mean?
Boost sensor B signal too high. The signal voltage from boost sensor B is above the maximum allowed. The control unit treats this as an electrical fault: a wire shorted to the supply, a broken sensor ground, or a faulty sensor.
Can I keep driving with code P0242 active?
With caution: limp mode possible, have it checked soon
Common causes — P0242
Wiring shorted to the supply voltage Broken or poor sensor ground Failed boost sensor B Damaged or corroded connector Faulty control unit (rare)
How do you fix code P0242?
Check the connector, wires and ground of sensor B. Since the control unit may reduce power, do not push the engine and have the circuit checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0241 — Boost sensor B signal too low
- Next code: P0243 — Wastegate solenoid A malfunction
Related codes
- P0200 — Injector circuit: general electrical fault
- P0201 — Injector cylinder 1: circuit
- P0202 — Injector circuit cylinder 2: electrical fault
- P0203 — Injector circuit cylinder 3: electrical fault
- P0204 — Injector circuit cylinder 4: electrical fault
- P0205 — Injector circuit cylinder 5: electrical fault
- P0206 — Injector circuit cylinder 6: electrical fault
- P0207 — Injector circuit cylinder 7: electrical fault
- P0208 — Injector circuit cylinder 8: electrical fault
- P0209 — Injector circuit cylinder 9: electrical fault
- P020A — Injector 1: performance out of range
- P020B — Injector 2: performance out of range