Skip to content
Fault code dictionary (DTC)

P024E — Charge air cooler bypass position sensor A low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe signal from the charge air cooler bypass position sensor is below the minimum allowed value. The control unit reads this as an electrical fault, for example a wire shorted to ground, a missing supply or a broken sensor.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Uneven turbo behavior
Possible loss of power
Possible protection mode
Abnormal intake air temperature

Common causes

Wiring shorted to ground
Missing supply to the sensor
Faulty position sensor
Corroded or damaged connector
Faulty control unit (rare)

What to do

Check the connector, wires and supply of the sensor. Have the circuit checked soon, because a missing signal can cause power to be limited.

How to read code P024E

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P024E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (4E) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P024E mean?

Charge air cooler bypass position sensor A low. The signal from the charge air cooler bypass position sensor is below the minimum allowed value. The control unit reads this as an electrical fault, for example a wire shorted to ground, a missing supply or a broken sensor.

Can I keep driving with code P024E active?

With caution: limp mode possible, have it checked soon

Common causes — P024E

Wiring shorted to ground Missing supply to the sensor Faulty position sensor Corroded or damaged connector Faulty control unit (rare)

How do you fix code P024E?

Check the connector, wires and supply of the sensor. Have the circuit checked soon, because a missing signal can cause power to be limited.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes