Skip to content
Fault code dictionary (DTC)

P024D — Charge air cooler bypass position sensor A implausible

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe charge air cooler bypass position sensor sends a signal, but it does not match what the control unit expects from the command given to the valve. The problem may be the sensor or a valve that does not reach the requested position.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Uneven turbo behavior
Possible loss of power
Possible protection mode
Abnormal intake air temperature

Common causes

Dirty or out-of-calibration position sensor
Valve that moves poorly
Loose or worn linkage
Connector with poor contact
Faulty actuator

What to do

Check that the valve moves freely and that the sensor connector is in good shape. Have it checked soon at a workshop, where requested and measured positions can be compared.

How to read code P024D

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P024D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (4D) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P024D mean?

Charge air cooler bypass position sensor A implausible. The charge air cooler bypass position sensor sends a signal, but it does not match what the control unit expects from the command given to the valve. The problem may be the sensor or a valve that does not reach the requested position.

Can I keep driving with code P024D active?

With caution: limp mode possible, have it checked soon

Common causes — P024D

Dirty or out-of-calibration position sensor Valve that moves poorly Loose or worn linkage Connector with poor contact Faulty actuator

How do you fix code P024D?

Check that the valve moves freely and that the sensor connector is in good shape. Have it checked soon at a workshop, where requested and measured positions can be compared.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes