P0292 — Cylinder 11 injector circuit, signal too high
| Meaning | The control unit detected a higher voltage than expected in the cylinder 11 injector circuit. It usually points to an electrical problem, such as a broken wire or one touching a power supply, more than a mechanical fault. It applies to engines with at least 11 cylinders. |
| Family | Powertrain (P) |
Typical symptoms
Dead cylinder and rough running
Loss of power
Fuel consumption that seems higher
Possible limp mode
Common causes
Wiring touching a power supply
Injector with an open coil
Fault in the control unit's driver stage
What to do
How to read code P0292
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0292 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (92) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0292 mean?
Cylinder 11 injector circuit, signal too high. The control unit detected a higher voltage than expected in the cylinder 11 injector circuit. It usually points to an electrical problem, such as a broken wire or one touching a power supply, more than a mechanical fault. It applies to engines with at least 11 cylinders.
Can I keep driving with code P0292 active?
With caution: limp mode possible, have it checked soon
Common causes — P0292
Broken wire or loose connector in the injector circuit Wiring touching a power supply Injector with an open coil Fault in the control unit's driver stage
How do you fix code P0292?
Have the connector, wiring and circuit continuity of the cylinder 11 injector checked. Don't put this off for long, because a dead cylinder puts extra strain on the rest of the engine and the exhaust.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0291 — Cylinder 11 injector circuit, signal too low
- Next code: P0293 — Cylinder 11 contribution or balance fault
Related codes
- P0200 — Injector circuit: general electrical fault
- P0201 — Injector cylinder 1: circuit
- P0202 — Injector circuit cylinder 2: electrical fault
- P0203 — Injector circuit cylinder 3: electrical fault
- P0204 — Injector circuit cylinder 4: electrical fault
- P0205 — Injector circuit cylinder 5: electrical fault
- P0206 — Injector circuit cylinder 6: electrical fault
- P0207 — Injector circuit cylinder 7: electrical fault
- P0208 — Injector circuit cylinder 8: electrical fault
- P0209 — Injector circuit cylinder 9: electrical fault
- P020A — Injector 1: performance out of range
- P020B — Injector 2: performance out of range