P02FE — Cold start fuel injection control circuit range/performance
| Meaning | The control unit found that the cold start control circuit is not working as expected, without the signal being simply open, too high or too low. The fault may be in the component, the wiring or the power supply. The system and its location depend on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Slow or uncertain cold starting
Uneven idle when cold
Smell of unburned fuel after starting
Normal running once warm
Common causes
Cold start component with resistance out of range
Wiring with abnormal resistance
Unstable supply voltage
Internal fault in the control unit
What to do
How to read code P02FE
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P02FE starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (FE) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P02FE mean?
Cold start fuel injection control circuit range/performance. The control unit found that the cold start control circuit is not working as expected, without the signal being simply open, too high or too low. The fault may be in the component, the wiring or the power supply. The system and its location depend on the manufacturer.
Can I keep driving with code P02FE active?
With caution: limp mode possible, have it checked soon
Common causes — P02FE
Connector with a weak or corroded contact Cold start component with resistance out of range Wiring with abnormal resistance Unstable supply voltage Internal fault in the control unit
How do you fix code P02FE?
Have the resistance of the cold start component measured and the connectors and power supply checked. Also check the state of the battery, because low voltage can distort the reading.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P02FD — Cold start fuel injection control circuit high
- Next code: P02FF — Vehicle inactive timer not performing correctly
Related codes
- P0200 — Injector circuit: general electrical fault
- P0201 — Injector cylinder 1: circuit
- P0202 — Injector circuit cylinder 2: electrical fault
- P0203 — Injector circuit cylinder 3: electrical fault
- P0204 — Injector circuit cylinder 4: electrical fault
- P0205 — Injector circuit cylinder 5: electrical fault
- P0206 — Injector circuit cylinder 6: electrical fault
- P0207 — Injector circuit cylinder 7: electrical fault
- P0208 — Injector circuit cylinder 8: electrical fault
- P0209 — Injector circuit cylinder 9: electrical fault
- P020A — Injector 1: performance out of range
- P020B — Injector 2: performance out of range