P057B — Brake pedal position sensor A range/performance
| Meaning | The signal from brake pedal position sensor A does not match what the control unit expects, for example compared with the brake light switch. The circuit is not necessarily open: the value is wrong or not believable. As a result the control unit may not trust the braking information. |
| Family | Powertrain (P) |
Typical symptoms
Cruise control will not engage or drops out
Brake lights behaving badly
Possible power reduction
Other warnings tied to driver assistance systems
Common causes
Faulty or misplaced brake light switch
Connector with a weak contact
Damaged wiring or abnormal resistance
Worn pedal position sensor
Internal control unit fault, which is very rare
What to do
How to read code P057B
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P057B starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (7B) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P057B mean?
Brake pedal position sensor A range/performance. The signal from brake pedal position sensor A does not match what the control unit expects, for example compared with the brake light switch. The circuit is not necessarily open: the value is wrong or not believable. As a result the control unit may not trust the braking information.
Can I keep driving with code P057B active?
With caution: limp mode possible, have it checked soon
Common causes — P057B
Pedal sensor out of adjustment or badly mounted Faulty or misplaced brake light switch Connector with a weak contact Damaged wiring or abnormal resistance Worn pedal position sensor Internal control unit fault, which is very rare
How do you fix code P057B?
First check that the brake lights work and the position of the sensor and switch on the pedal. Then check the connectors and wiring. Have the car looked at promptly, because brake lights are a safety item.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P057A — Brake pedal position sensor A circuit open
- Next code: P057C — Brake pedal position sensor A signal too low
Related codes
- P0500 — Vehicle Speed Sensor Malfunction
- P0501 — Vehicle speed sensor: implausible value
- P0502 — Vehicle speed sensor circuit low input
- P0503 — Vehicle speed sensor intermittent, erratic or high
- P0504 — Brake Switch Correlation Error
- P0505 — Idle Control System Malfunction
- P0506 — Idle speed lower than expected
- P0507 — Idle Control System RPM Higher Than Expected
- P0508 — Idle air control circuit low
- P0509 — Idle air control circuit high
- P050A — Cold start idle control system performance
- P050B — Cold start ignition timing performance