P057C — Brake pedal position sensor A signal too low
| Meaning | The control unit reads a lower than normal voltage on brake pedal position sensor A. It usually points to a wire shorted to ground, a short circuit or a faulty sensor. The braking information then becomes unreliable. |
| Family | Powertrain (P) |
Typical symptoms
Cruise control disabled
Brake lights always on or not working
Possible power limitation
Messages or warnings from other assistance systems
Common causes
Faulty pedal sensor
Corroded connector or water in it
Damaged wiring near the pedal
Missing or weak sensor supply
Internal control unit fault, which is rare
What to do
How to read code P057C
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P057C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (7C) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P057C mean?
Brake pedal position sensor A signal too low. The control unit reads a lower than normal voltage on brake pedal position sensor A. It usually points to a wire shorted to ground, a short circuit or a faulty sensor. The braking information then becomes unreliable.
Can I keep driving with code P057C active?
With caution: limp mode possible, have it checked soon
Common causes — P057C
Signal wire touching ground through chafing Faulty pedal sensor Corroded connector or water in it Damaged wiring near the pedal Missing or weak sensor supply Internal control unit fault, which is rare
How do you fix code P057C?
Check the brake lights straight away, since a fault is a danger to the traffic behind you. Then inspect the sensor wiring and connector at the pedal, looking for pinched wires or moisture. Do not put the check off.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P057B — Brake pedal position sensor A range/performance
- Next code: P057D — Brake pedal position sensor A signal too high
Related codes
- P0500 — Vehicle Speed Sensor Malfunction
- P0501 — Vehicle speed sensor: implausible value
- P0502 — Vehicle speed sensor circuit low input
- P0503 — Vehicle speed sensor intermittent, erratic or high
- P0504 — Brake Switch Correlation Error
- P0505 — Idle Control System Malfunction
- P0506 — Idle speed lower than expected
- P0507 — Idle Control System RPM Higher Than Expected
- P0508 — Idle air control circuit low
- P0509 — Idle air control circuit high
- P050A — Cold start idle control system performance
- P050B — Cold start ignition timing performance