P057D — Brake pedal position sensor A signal too high
| Meaning | The control unit reads a higher than normal voltage on brake pedal position sensor A. It can come from a short to the supply, a broken ground wire or a faulty sensor. The signal cannot be used. |
| Family | Powertrain (P) |
Typical symptoms
Cruise control not working
Odd brake light behavior
Possible power reduction
Other warnings from braking-related systems
Common causes
Signal wire shorted to the supply
Faulty pedal sensor
Corroded or damaged connector
Pinched or damaged wiring
Internal control unit fault, which is rare
What to do
How to read code P057D
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P057D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (7D) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P057D mean?
Brake pedal position sensor A signal too high. The control unit reads a higher than normal voltage on brake pedal position sensor A. It can come from a short to the supply, a broken ground wire or a faulty sensor. The signal cannot be used.
Can I keep driving with code P057D active?
With caution: limp mode possible, have it checked soon
Common causes — P057D
Sensor ground wire broken or with a poor contact Signal wire shorted to the supply Faulty pedal sensor Corroded or damaged connector Pinched or damaged wiring Internal control unit fault, which is rare
How do you fix code P057D?
First check the brake lights and the condition of the connector at the pedal. Then check the sensor ground and wiring. Have the check done within a short time.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P057C — Brake pedal position sensor A signal too low
- Next code: P057E — Brake pedal position sensor A intermittent signal
Related codes
- P0500 — Vehicle Speed Sensor Malfunction
- P0501 — Vehicle speed sensor: implausible value
- P0502 — Vehicle speed sensor circuit low input
- P0503 — Vehicle speed sensor intermittent, erratic or high
- P0504 — Brake Switch Correlation Error
- P0505 — Idle Control System Malfunction
- P0506 — Idle speed lower than expected
- P0507 — Idle Control System RPM Higher Than Expected
- P0508 — Idle air control circuit low
- P0509 — Idle air control circuit high
- P050A — Cold start idle control system performance
- P050B — Cold start ignition timing performance