P057E — Brake pedal position sensor A intermittent signal
| Meaning | The signal from brake pedal position sensor A drops out or becomes unstable from time to time. The control unit sees it when the value jumps without you moving the pedal. It is usually a contact that is lost through vibration or movement. |
| Family | Powertrain (P) |
Typical symptoms
Cruise control dropping out by itself
Brake lights coming on or off at random
Possible brief power dips
Symptoms that appear on rough roads or with the pedal pressed in certain ways
Common causes
Wire partly broken from wear near the pedal
Pedal sensor starting to fail
Moisture or corrosion in the contacts
Loose sensor mounting
Internal control unit fault, which is very rare
What to do
How to read code P057E
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P057E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (7E) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P057E mean?
Brake pedal position sensor A intermittent signal. The signal from brake pedal position sensor A drops out or becomes unstable from time to time. The control unit sees it when the value jumps without you moving the pedal. It is usually a contact that is lost through vibration or movement.
Can I keep driving with code P057E active?
With caution: limp mode possible, have it checked soon
Common causes — P057E
Sensor connector with a weak contact Wire partly broken from wear near the pedal Pedal sensor starting to fail Moisture or corrosion in the contacts Loose sensor mounting Internal control unit fault, which is very rare
How do you fix code P057E?
Carefully move the wiring and connector at the pedal with the engine running and see whether the signal changes. Also check the brake lights. Intermittent faults tend to get worse, so it is best to have them checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P057D — Brake pedal position sensor A signal too high
- Next code: P057F — Battery A state of charge performance
Related codes
- P0500 — Vehicle Speed Sensor Malfunction
- P0501 — Vehicle speed sensor: implausible value
- P0502 — Vehicle speed sensor circuit low input
- P0503 — Vehicle speed sensor intermittent, erratic or high
- P0504 — Brake Switch Correlation Error
- P0505 — Idle Control System Malfunction
- P0506 — Idle speed lower than expected
- P0507 — Idle Control System RPM Higher Than Expected
- P0508 — Idle air control circuit low
- P0509 — Idle air control circuit high
- P050A — Cold start idle control system performance
- P050B — Cold start ignition timing performance