P059C — Active grille air shutter A position sensor circuit high
| Meaning | The control unit found too high a voltage in the position sensor circuit of active grille shutter A, the slats that manage air in front of the radiator. It usually points to a broken wire, an open contact or a short to supply voltage. |
| Family | Powertrain (P) |
Typical symptoms
Grille slats stuck in one position
Higher engine temperature in traffic
Cooling fan working harder
Higher fuel use at high speed
Common causes
Wire shorted to supply voltage
Faulty position sensor
Corroded terminals
Control unit with a circuit fault
What to do
How to read code P059C
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P059C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (9C) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P059C mean?
Active grille air shutter A position sensor circuit high. The control unit found too high a voltage in the position sensor circuit of active grille shutter A, the slats that manage air in front of the radiator. It usually points to a broken wire, an open contact or a short to supply voltage.
Can I keep driving with code P059C active?
With caution: limp mode possible, have it checked soon
Common causes — P059C
Broken sensor wire or unplugged connector Wire shorted to supply voltage Faulty position sensor Corroded terminals Control unit with a circuit fault
How do you fix code P059C?
Have the sensor connector and wiring checked for broken wires or shorts, then the sensor. Keep an eye on engine temperature, though it is usually not an emergency.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P059B — Active grille air shutter A position sensor range/...
- Next code: P059D — Active grille air shutter A position sensor circui...
Related codes
- P0500 — Vehicle Speed Sensor Malfunction
- P0501 — Vehicle speed sensor: implausible value
- P0502 — Vehicle speed sensor circuit low input
- P0503 — Vehicle speed sensor intermittent, erratic or high
- P0504 — Brake Switch Correlation Error
- P0505 — Idle Control System Malfunction
- P0506 — Idle speed lower than expected
- P0507 — Idle Control System RPM Higher Than Expected
- P0508 — Idle air control circuit low
- P0509 — Idle air control circuit high
- P050A — Cold start idle control system performance
- P050B — Cold start ignition timing performance