Skip to content
Fault code dictionary (DTC)

P060B — Internal control module A/D conversion fault

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit turns sensor signals, which are voltages, into numbers it can process. With this code it found an error in that internal conversion. If the conversion is wrong, the values read from the sensors can be distorted.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Inconsistent sensor readings
Rough running or hesitation
Unusual performance or fuel use
Hard starting

Common causes

Unstable power or ground for the sensors and control unit
Corrosion in the control unit connectors
Software needing an update
A short on a sensor supply line disturbing the control unit
Internal failure of the control unit

What to do

Have the power supply and grounds checked, and see whether other codes point to a shorted sensor, since that can upset the control unit. Do not ignore it for long, but it does not usually force you to stop right away.

How to read code P060B

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P060B starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (0B) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P060B mean?

Internal control module A/D conversion fault. The control unit turns sensor signals, which are voltages, into numbers it can process. With this code it found an error in that internal conversion. If the conversion is wrong, the values read from the sensors can be distorted.

Can I keep driving with code P060B active?

With caution: limp mode possible, have it checked soon

Common causes — P060B

Unstable power or ground for the sensors and control unit Corrosion in the control unit connectors Software needing an update A short on a sensor supply line disturbing the control unit Internal failure of the control unit

How do you fix code P060B?

Have the power supply and grounds checked, and see whether other codes point to a shorted sensor, since that can upset the control unit. Do not ignore it for long, but it does not usually force you to stop right away.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes