P064A — Fuel pump control module A fault
| Meaning | The engine control unit detected a problem in the module that controls the fuel pump, meaning the electronics that regulate how much pressure the pump delivers. The code points to a fault in the module or in how it operates. On cars with a separate module like this, a malfunction can reduce or cut the fuel supply to the engine. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power, especially under load
Engine suddenly stalling
Jerking or hesitation when accelerating
Check engine light on
Reduced-power (limp) mode
Common causes
Insufficient power or ground supply to the module
Corroded connectors or damaged wiring
Faulty fuel pump fuse or relay
Fuel pump drawing abnormal current
Communication problem between the module and the control unit
What to do
How to read code P064A
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P064A starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (4A) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P064A mean?
Fuel pump control module A fault. The engine control unit detected a problem in the module that controls the fuel pump, meaning the electronics that regulate how much pressure the pump delivers. The code points to a fault in the module or in how it operates. On cars with a separate module like this, a malfunction can reduce or cut the fuel supply to the engine.
Can I keep driving with code P064A active?
With caution: limp mode possible, have it checked soon
Common causes — P064A
Faulty pump control module Insufficient power or ground supply to the module Corroded connectors or damaged wiring Faulty fuel pump fuse or relay Fuel pump drawing abnormal current Communication problem between the module and the control unit
How do you fix code P064A?
Have the module's power, ground and connectors checked right away, then the pump's operation. A car that can stall while you're driving is a real risk, especially in traffic, so avoid long trips until it's resolved.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0649 — Cruise control lamp control circuit fault
- Next code: P064B — Power take-off (PTO) control module fault
Related codes
- P0600 — Serial communication link malfunction
- P0601 — Internal Control Module Memory Check Sum Error
- P0602 — Control module programming error
- P0603 — Internal Control Module Keep Alive Memory (KAM) Error
- P0604 — Internal control module RAM error
- P0605 — Internal Control Module Read Only Memory (ROM) Error
- P0606 — Control module processor fault
- P0607 — Control module performance out of range
- P0608 — Control module speed signal output A malfunction
- P0609 — Control module speed signal output B malfunction
- P060A — Internal control module monitoring processor fault
- P060B — Internal control module A/D conversion fault