P064E — Control unit O2 sensor processing fault, bank 2
| Meaning | The control unit detected a problem in the internal section that processes the signal from the oxygen (lambda) sensors on bank 2. Bank 2 is the side of the engine opposite cylinder 1, on V or flat engines. The fault is in the internal processing, not in the sensor itself. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle
Fuel consumption different from usual
Loss of power
Failing the emissions inspection
Common causes
Insufficient power or ground supply to the control unit
Corroded or damaged control unit connectors
Control unit software needing an update
Damaged bank 2 sensor wiring
Moisture intrusion into the control unit
What to do
How to read code P064E
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P064E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (4E) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P064E mean?
Control unit O2 sensor processing fault, bank 2. The control unit detected a problem in the internal section that processes the signal from the oxygen (lambda) sensors on bank 2. Bank 2 is the side of the engine opposite cylinder 1, on V or flat engines. The fault is in the internal processing, not in the sensor itself.
Can I keep driving with code P064E active?
With caution: limp mode possible, have it checked soon
Common causes — P064E
Internal fault in the engine control unit Insufficient power or ground supply to the control unit Corroded or damaged control unit connectors Control unit software needing an update Damaged bank 2 sensor wiring Moisture intrusion into the control unit
How do you fix code P064E?
Before suspecting the control unit, have the battery, grounds, connectors and bank 2 sensor wiring checked, and see whether a software update exists. The car can usually be driven, but it's best to act soon to avoid fouling the catalytic converter.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P064D — Oxygen sensor module: internal performance fault
- Next code: P064F — Unauthorized software or calibration detected
Related codes
- P0600 — Serial communication link malfunction
- P0601 — Internal Control Module Memory Check Sum Error
- P0602 — Control module programming error
- P0603 — Internal Control Module Keep Alive Memory (KAM) Error
- P0604 — Internal control module RAM error
- P0605 — Internal Control Module Read Only Memory (ROM) Error
- P0606 — Control module processor fault
- P0607 — Control module performance out of range
- P0608 — Control module speed signal output A malfunction
- P0609 — Control module speed signal output B malfunction
- P060A — Internal control module monitoring processor fault
- P060B — Internal control module A/D conversion fault