P0698 — Sensor reference voltage "C" circuit low
| Meaning | The control unit supplies a regulated reference voltage, usually 5 volts, to a group of sensors. On circuit "C" it detected a lower voltage than expected. Which sensors share it depends on the manufacturer, and I have no reliable basis to name them in general. |
| Family | Powertrain (P) |
Typical symptoms
Engine running poorly or with low power
Unstable idle
Several sensor codes set at the same time
Engine in limp mode
Common causes
Sensor wiring damaged or pinched
Connector with moisture or corrosion
Control unit ground in poor condition
Internal control unit fault (uncommon)
What to do
How to read code P0698
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0698 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (98) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0698 mean?
Sensor reference voltage "C" circuit low. The control unit supplies a regulated reference voltage, usually 5 volts, to a group of sensors. On circuit "C" it detected a lower voltage than expected. Which sensors share it depends on the manufacturer, and I have no reliable basis to name them in general.
Can I keep driving with code P0698 active?
With caution: limp mode possible, have it checked soon
Common causes — P0698
A connected sensor shorted to ground Sensor wiring damaged or pinched Connector with moisture or corrosion Control unit ground in poor condition Internal control unit fault (uncommon)
How do you fix code P0698?
See whether several sensor codes appear together, then check the wiring and connectors of the sensors on that circuit. If the engine goes into limp mode or loses power, have the car checked urgently.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0697 — Sensor reference voltage "C" circuit open
- Next code: P0699 — Sensor reference voltage C circuit high
Related codes
- P0600 — Serial communication link malfunction
- P0601 — Internal Control Module Memory Check Sum Error
- P0602 — Control module programming error
- P0603 — Internal Control Module Keep Alive Memory (KAM) Error
- P0604 — Internal control module RAM error
- P0605 — Internal Control Module Read Only Memory (ROM) Error
- P0606 — Control module processor fault
- P0607 — Control module performance out of range
- P0608 — Control module speed signal output A malfunction
- P0609 — Control module speed signal output B malfunction
- P060A — Internal control module monitoring processor fault
- P060B — Internal control module A/D conversion fault