P069D — Cylinder 10 glow plug control circuit high
| Meaning | The control unit measured a voltage that is too high in the control circuit of the cylinder 10 glow plug. It may be a short to the supply or a module fault. This code applies to engines with at least ten cylinders. |
| Family | Powertrain (P) |
Typical symptoms
Hard cold starting
Smoke at cold start
Rough running in the first minutes
The glow plug module may protect itself and shut down
Common causes
Glow plug short circuit
Damaged or wet connector
Faulty output in the control module
Poorly done earlier repair
What to do
How to read code P069D
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P069D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (9D) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P069D mean?
Cylinder 10 glow plug control circuit high. The control unit measured a voltage that is too high in the control circuit of the cylinder 10 glow plug. It may be a short to the supply or a module fault. This code applies to engines with at least ten cylinders.
Can I keep driving with code P069D active?
With caution: limp mode possible, have it checked soon
Common causes — P069D
Wiring shorted to the supply Glow plug short circuit Damaged or wet connector Faulty output in the control module Poorly done earlier repair
How do you fix code P069D?
Inspect the wiring and connector of the cylinder 10 glow plug for damaged insulation or heat marks. A short can overheat the wires, so don't put the check off for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P069C — Cylinder 10 glow plug control circuit low
- Next code: P069E — Fuel pump control module requested warning light
Related codes
- P0600 — Serial communication link malfunction
- P0601 — Internal Control Module Memory Check Sum Error
- P0602 — Control module programming error
- P0603 — Internal Control Module Keep Alive Memory (KAM) Error
- P0604 — Internal control module RAM error
- P0605 — Internal Control Module Read Only Memory (ROM) Error
- P0606 — Control module processor fault
- P0607 — Control module performance out of range
- P0608 — Control module speed signal output A malfunction
- P0609 — Control module speed signal output B malfunction
- P060A — Internal control module monitoring processor fault
- P060B — Internal control module A/D conversion fault