Skip to content
Fault code dictionary (DTC)

P06AC — Control module internal temperature sensor B range/performance

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control module found the reading of its own internal temperature sensor 'B' implausible, for example too different from other sensors or stuck at one value. The sensor is inside the module. Which module is affected depends on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Usually no obvious change in driving
Possible reduced operation for protection
Other communication codes
Irregular behaviour in rare cases

Common causes

Internal module sensor out of calibration or faulty
Supply or ground problems
Moisture or corrosion inside the module
Corroded module connector
Internal module fault

What to do

Check the module's supply, grounds and connectors. If the code stays, the problem is probably internal: it isn't urgent, but have it checked to avoid sudden protection modes.

How to read code P06AC

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P06AC starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (AC) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P06AC mean?

Control module internal temperature sensor B range/performance. The control module found the reading of its own internal temperature sensor 'B' implausible, for example too different from other sensors or stuck at one value. The sensor is inside the module. Which module is affected depends on the manufacturer.

Can I keep driving with code P06AC active?

With caution: limp mode possible, have it checked soon

Common causes — P06AC

Internal module sensor out of calibration or faulty Supply or ground problems Moisture or corrosion inside the module Corroded module connector Internal module fault

How do you fix code P06AC?

Check the module's supply, grounds and connectors. If the code stays, the problem is probably internal: it isn't urgent, but have it checked to avoid sudden protection modes.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes