P06AE — Control module internal temperature sensor B: signal too high
| Meaning | The engine control module measures its own internal temperature with a sensor. Circuit "B" is reporting a value higher than is plausible. It can be a circuit or module fault, or genuine overheating, for example from engine bay heat. |
| Family | Powertrain (P) |
Typical symptoms
No obvious symptom while driving
Occasional reduced performance
Other codes stored along with this one
Irregular engine behavior when hot
Common causes
Module exposed to excessive heat or poorly mounted
High resistance in the module ground or power supply
Moisture or corrosion in the connector
Abnormal system voltage from a struggling battery or alternator
What to do
How to read code P06AE
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P06AE starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (AE) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P06AE mean?
Control module internal temperature sensor B: signal too high. The engine control module measures its own internal temperature with a sensor. Circuit "B" is reporting a value higher than is plausible. It can be a circuit or module fault, or genuine overheating, for example from engine bay heat.
Can I keep driving with code P06AE active?
With caution: limp mode possible, have it checked soon
Common causes — P06AE
Internal fault in the control module Module exposed to excessive heat or poorly mounted High resistance in the module ground or power supply Moisture or corrosion in the connector Abnormal system voltage from a struggling battery or alternator
How do you fix code P06AE?
Check the battery, alternator charging, grounds and control module connectors. Also check that there is no heat source or fluid leak near the module. If the code returns, have it diagnosed in a workshop: the module should be looked at before the problem gets worse.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P06AD — Control module internal temperature sensor B: sign...
- Next code: P06AF — Torque management: forced engine shutdown
Related codes
- P0600 — Serial communication link malfunction
- P0601 — Internal Control Module Memory Check Sum Error
- P0602 — Control module programming error
- P0603 — Internal Control Module Keep Alive Memory (KAM) Error
- P0604 — Internal control module RAM error
- P0605 — Internal Control Module Read Only Memory (ROM) Error
- P0606 — Control module processor fault
- P0607 — Control module performance out of range
- P0608 — Control module speed signal output A malfunction
- P0609 — Control module speed signal output B malfunction
- P060A — Internal control module monitoring processor fault
- P060B — Internal control module A/D conversion fault