P06B0 — Sensor power supply A: open circuit or fault
| Meaning | The control module supplies a reference voltage to sensors, usually 5 volts. On supply "A" it has detected an open circuit or a fault. Which sensors are on branch A depends on the manufacturer, so the wiring diagram for your car is needed. |
| Family | Powertrain (P) |
Typical symptoms
Engine running rough or jerking
Loss of power
Limp mode
Several different sensor codes at once
Common causes
A faulty or unplugged sensor on that branch
Corrosion in the connectors
Wiring damage from chafing or rodents
Internal control module fault
What to do
How to read code P06B0
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P06B0 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (B0) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P06B0 mean?
Sensor power supply A: open circuit or fault. The control module supplies a reference voltage to sensors, usually 5 volts. On supply "A" it has detected an open circuit or a fault. Which sensors are on branch A depends on the manufacturer, so the wiring diagram for your car is needed.
Can I keep driving with code P06B0 active?
With caution: limp mode possible, have it checked soon
Common causes — P06B0
Broken wire or loose connector on the supply branch A faulty or unplugged sensor on that branch Corrosion in the connectors Wiring damage from chafing or rodents Internal control module fault
How do you fix code P06B0?
If you have several different sensor codes together, suspect this shared supply. Check the connectors and wiring of the sensors on that branch. If you have power loss or stalling, don't put off the diagnosis.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P06AF — Torque management: forced engine shutdown
- Next code: P06B1 — Sensor power supply A: voltage too low
Related codes
- P0600 — Serial communication link malfunction
- P0601 — Internal Control Module Memory Check Sum Error
- P0602 — Control module programming error
- P0603 — Internal Control Module Keep Alive Memory (KAM) Error
- P0604 — Internal control module RAM error
- P0605 — Internal Control Module Read Only Memory (ROM) Error
- P0606 — Control module processor fault
- P0607 — Control module performance out of range
- P0608 — Control module speed signal output A malfunction
- P0609 — Control module speed signal output B malfunction
- P060A — Internal control module monitoring processor fault
- P060B — Internal control module A/D conversion fault