P06C7 — Cylinder 3 glow plug incorrect
| Meaning | The control unit found that the cylinder 3 glow plug is not behaving as expected. The code alone does not tell whether the fault is the glow plug, the wiring or the control. The exact criterion the unit uses to judge a glow plug "incorrect" can differ between manufacturers, so diagnosis needs measurements on the circuit. |
| Family | Powertrain (P) |
Typical symptoms
White or grey smoke after a cold start
Rough running while the engine is cold
Glow plug or engine warning light on
Noisier engine during the first minutes
Common causes
Wrong glow plug type fitted in an earlier replacement
Faulty contact in the glow plug connector or wiring
Glow plug control module with an incorrect output
Insufficient supply from a weak battery or poor grounds
What to do
How to read code P06C7
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P06C7 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (C7) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P06C7 mean?
Cylinder 3 glow plug incorrect. The control unit found that the cylinder 3 glow plug is not behaving as expected. The code alone does not tell whether the fault is the glow plug, the wiring or the control. The exact criterion the unit uses to judge a glow plug "incorrect" can differ between manufacturers, so diagnosis needs measurements on the circuit.
Can I keep driving with code P06C7 active?
With caution: limp mode possible, have it checked soon
Common causes — P06C7
Worn cylinder 3 glow plug or one with altered electrical characteristics Wrong glow plug type fitted in an earlier replacement Faulty contact in the glow plug connector or wiring Glow plug control module with an incorrect output Insufficient supply from a weak battery or poor grounds
How do you fix code P06C7?
Have the glow plug measured and check that the fitted part is the one specified for your engine. It will not stop the car straight away, but it is best checked before the cold season.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P06C6 — Cylinder 2 glow plug incorrect
- Next code: P06C8 — Cylinder 4 glow plug incorrect
Related codes
- P0600 — Serial communication link malfunction
- P0601 — Internal Control Module Memory Check Sum Error
- P0602 — Control module programming error
- P0603 — Internal Control Module Keep Alive Memory (KAM) Error
- P0604 — Internal control module RAM error
- P0605 — Internal Control Module Read Only Memory (ROM) Error
- P0606 — Control module processor fault
- P0607 — Control module performance out of range
- P0608 — Control module speed signal output A malfunction
- P0609 — Control module speed signal output B malfunction
- P060A — Internal control module monitoring processor fault
- P060B — Internal control module A/D conversion fault