Skip to content
Fault code dictionary (DTC)

P06E7 — Sensor power supply C: voltage too low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe engine control unit provides a supply voltage to a group of sensors, labelled circuit "C". It measured a voltage below the expected minimum. This usually means the line is shorting to ground or a connected component is drawing too much current. Which sensors are involved depends on the manufacturer and must be checked against the wiring diagram for your brand.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Reduced power or limp mode
Uneven running under acceleration
Sensor readings stuck or nonsensical on the scan tool
Other sensor codes appearing together

Common causes

Supply wire touching ground through damaged insulation
Sensor with an internal short
Wet or dirty connector
Wiring pinched or burnt near hot parts
Internal fault in the control unit

What to do

First check the wiring and connectors of the sensors on that line, looking for chafing, moisture or burn marks. Then unplug the sensors one at a time to find which one pulls the voltage down. It is wise to act soon.

How to read code P06E7

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P06E7 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (E7) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P06E7 mean?

Sensor power supply C: voltage too low. The engine control unit provides a supply voltage to a group of sensors, labelled circuit "C". It measured a voltage below the expected minimum. This usually means the line is shorting to ground or a connected component is drawing too much current. Which sensors are involved depends on the manufacturer and must be checked against the wiring diagram for your brand.

Can I keep driving with code P06E7 active?

With caution: limp mode possible, have it checked soon

Common causes — P06E7

Supply wire touching ground through damaged insulation Sensor with an internal short Wet or dirty connector Wiring pinched or burnt near hot parts Internal fault in the control unit

How do you fix code P06E7?

First check the wiring and connectors of the sensors on that line, looking for chafing, moisture or burn marks. Then unplug the sensors one at a time to find which one pulls the voltage down. It is wise to act soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes