P06EB — Downstream NOx sensor control unit performance fault
| Meaning | The control unit found that the electronics processing the signal of the NOx sensor after the SCR catalyst (bank 1, sensor 2) are not working correctly. This sensor is used to check how much the AdBlue system has reduced nitrogen oxides. The problem may be in the module, the sensor or the wiring. |
| Family | Powertrain (P) |
Typical symptoms
Warning about the emissions system or AdBlue
Possible reduction in power
Possible start limitation if the fault persists
Failed emissions test
Common causes
Damaged or corroded wiring or connector
Aged sensor or one fouled by exhaust residues
Irregular sensor power supply or ground
Communication problem with the control unit
What to do
How to read code P06EB
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P06EB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (EB) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P06EB mean?
Downstream NOx sensor control unit performance fault. The control unit found that the electronics processing the signal of the NOx sensor after the SCR catalyst (bank 1, sensor 2) are not working correctly. This sensor is used to check how much the AdBlue system has reduced nitrogen oxides. The problem may be in the module, the sensor or the wiring.
Can I keep driving with code P06EB active?
With caution: limp mode possible, have it checked soon
Common causes — P06EB
Faulty NOx sensor with electronic module Damaged or corroded wiring or connector Aged sensor or one fouled by exhaust residues Irregular sensor power supply or ground Communication problem with the control unit
How do you fix code P06EB?
Have the sensor data checked with a diagnostic tool, along with the connector and wiring. Don't ignore the code for long: the emissions system may impose restrictions.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P06EA — Upstream NOx sensor control unit performance fault
- Next code: P06EC — Injector control module requested check engine lig...
Related codes
- P0600 — Serial communication link malfunction
- P0601 — Internal Control Module Memory Check Sum Error
- P0602 — Control module programming error
- P0603 — Internal Control Module Keep Alive Memory (KAM) Error
- P0604 — Internal control module RAM error
- P0605 — Internal Control Module Read Only Memory (ROM) Error
- P0606 — Control module processor fault
- P0607 — Control module performance out of range
- P0608 — Control module speed signal output A malfunction
- P0609 — Control module speed signal output B malfunction
- P060A — Internal control module monitoring processor fault
- P060B — Internal control module A/D conversion fault