P07A2 — Transmission friction element A performance or stuck off
| Meaning | The control module saw that friction element A, meaning an internal clutch or brake of the gearbox, does not engage as requested: it stays open or does not carry the expected torque. The letter A is a manufacturer label, and I have no reliable information on which element it indicates on your brand. It may come from missing oil pressure or from wear. |
| Family | Powertrain (P) |
Typical symptoms
Engine revs rising without the car moving forward
Delayed or banging shifts
Gearbox in limp mode
Transmission or check engine light on
Common causes
Solenoid not sending pressure to the clutch
Worn valve body or blocked passages
Worn clutch or plates
Damaged clutch piston seals
Weak oil pump, less common
What to do
How to read code P07A2
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P07A2 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (A2) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P07A2 mean?
Transmission friction element A performance or stuck off. The control module saw that friction element A, meaning an internal clutch or brake of the gearbox, does not engage as requested: it stays open or does not carry the expected torque. The letter A is a manufacturer label, and I have no reliable information on which element it indicates on your brand. It may come from missing oil pressure or from wear.
Can I keep driving with code P07A2 active?
With caution: limp mode possible, have it checked soon
Common causes — P07A2
Low or degraded gearbox oil Solenoid not sending pressure to the clutch Worn valve body or blocked passages Worn clutch or plates Damaged clutch piston seals Weak oil pump, less common
How do you fix code P07A2?
First check the gearbox oil level and condition. If a gear is missing or the gearbox slips, use the car less and have the gearbox diagnosed soon, because the fault can get worse.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P07A1 — Transmission friction element H slip detected
- Next code: P07A3 — Transmission friction element A stuck engaged
Related codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0704 — Clutch switch input circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible