P07A3 — Transmission friction element A stuck engaged
| Meaning | The transmission control unit detected that an internal friction element, labelled "A", stays engaged when it should be released. Friction elements are the clutches and brake packs an automatic gearbox uses to select gears. Which part the letter A refers to is set by the manufacturer, so your make's service data is needed to know which gear is involved. |
| Family | Powertrain (P) |
Typical symptoms
A feeling that the car is being held back or braked while driving
Engine tending to stall when selecting D or R
Gearbox going into limp mode and staying in one gear
Engine or transmission warning light on
Burning smell from the gearbox after a drive
Common causes
Dirty, degraded or incorrectly filled transmission fluid
Valve body with debris or wear
Damaged or stuck clutch or brake pack
Faulty wiring or connector at the solenoid
Internal fault in the transmission control unit
What to do
How to read code P07A3
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P07A3 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (A3) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P07A3 mean?
Transmission friction element A stuck engaged. The transmission control unit detected that an internal friction element, labelled "A", stays engaged when it should be released. Friction elements are the clutches and brake packs an automatic gearbox uses to select gears. Which part the letter A refers to is set by the manufacturer, so your make's service data is needed to know which gear is involved.
Can I keep driving with code P07A3 active?
With caution: limp mode possible, have it checked soon
Common causes — P07A3
Gearbox solenoid that fails to release pressure and stays open Dirty, degraded or incorrectly filled transmission fluid Valve body with debris or wear Damaged or stuck clutch or brake pack Faulty wiring or connector at the solenoid Internal fault in the transmission control unit
How do you fix code P07A3?
Avoid long drives with the light on, because an element that stays engaged heats up and wears the gearbox. Have the fluid level and condition checked and any other stored codes read. Then have a workshop check the transmission following the manufacturer's procedure, without leaving it too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P07A2 — Transmission friction element A performance or stu...
- Next code: P07A4 — Transmission friction element B slipping or not en...
Related codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0704 — Clutch switch input circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible