Skip to content
Fault code dictionary (DTC)

P07AE — Transmission friction element G slipping or not engaging

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe transmission control unit detected that internal friction element "G" is not engaging as commanded or is not holding. These are the clutches and brake packs of the automatic gearbox, typical of gearboxes with many gears. The letter G is assigned by the manufacturer, so the affected gear depends on your make.
FamilyPowertrain (P)

Typical symptoms

High engine revs without matching acceleration
Delayed or missing engagement of a gear
Harsh or slipping shifts
Loss of power when accelerating
Gearbox in limp mode
Engine or transmission warning light on

Common causes

Low, degraded or contaminated transmission fluid
Worn clutch or brake pack
Solenoid not delivering the required pressure
Pressure loss in the internal hydraulic circuit
Faulty wiring or connector
Fault in the transmission control unit

What to do

First check the fluid level and condition, following the manufacturer. If it slips, reduce use of the car, because the plates wear quickly. Have the codes read and the gearbox checked at a workshop soon.

How to read code P07AE

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P07AE starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (AE) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P07AE mean?

Transmission friction element G slipping or not engaging. The transmission control unit detected that internal friction element "G" is not engaging as commanded or is not holding. These are the clutches and brake packs of the automatic gearbox, typical of gearboxes with many gears. The letter G is assigned by the manufacturer, so the affected gear depends on your make.

Can I keep driving with code P07AE active?

With caution: limp mode possible, have it checked soon

Common causes — P07AE

Low, degraded or contaminated transmission fluid Worn clutch or brake pack Solenoid not delivering the required pressure Pressure loss in the internal hydraulic circuit Faulty wiring or connector Fault in the transmission control unit

How do you fix code P07AE?

First check the fluid level and condition, following the manufacturer. If it slips, reduce use of the car, because the plates wear quickly. Have the codes read and the gearbox checked at a workshop soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes