P07AF — Transmission friction element G stuck engaged
| Meaning | The transmission control unit detected that internal friction element "G" stays engaged when it should be released. It is a clutch or brake pack in the automatic gearbox. The letter G is chosen by the manufacturer, so the gear involved must be checked in your make's service data. |
| Family | Powertrain (P) |
Typical symptoms
The car feeling held back while driving
Engine tending to stall in D or R
Gearbox locked in one gear
Engine or transmission warning light on
Burning smell from the gearbox
Common causes
Dirty, degraded or incorrectly filled transmission fluid
Valve body with debris or wear
Damaged clutch or brake pack
Faulty wiring or connector
Internal fault in the transmission control unit
What to do
How to read code P07AF
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P07AF starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (AF) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P07AF mean?
Transmission friction element G stuck engaged. The transmission control unit detected that internal friction element "G" stays engaged when it should be released. It is a clutch or brake pack in the automatic gearbox. The letter G is chosen by the manufacturer, so the gear involved must be checked in your make's service data.
Can I keep driving with code P07AF active?
With caution: limp mode possible, have it checked soon
Common causes — P07AF
Solenoid that stays open Dirty, degraded or incorrectly filled transmission fluid Valve body with debris or wear Damaged clutch or brake pack Faulty wiring or connector Internal fault in the transmission control unit
How do you fix code P07AF?
Avoid driving for long with the light on, because the gearbox can overheat. Have the fluid and stored codes checked. Then have a workshop inspect the gearbox without leaving it too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P07AE — Transmission friction element G slipping or not en...
- Next code: P07B0 — Transmission friction element H slipping or not en...
Related codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0704 — Clutch switch input circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible