P07B2 — Park position sensor/switch A: open circuit
| Meaning | The transmission control unit detected an open, meaning broken, circuit in sensor or switch "A" that reports whether the lever is in Park. Without this signal the control unit cannot be sure the gearbox is in Park. Where the sensor is and how it is built varies from make to make. |
| Family | Powertrain (P) |
Typical symptoms
Wrong or missing gear indication on the dashboard
Lever stuck and not releasing from Park
Reverse lights not working properly
Transmission or engine warning light on
Gearbox going into limp mode
Common causes
Broken or damaged wiring
Faulty position sensor or switch
Sensor out of adjustment relative to the lever
Worn or badly adjusted selector lever or linkage
Fault in the transmission control unit
What to do
How to read code P07B2
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P07B2 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (B2) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P07B2 mean?
Park position sensor/switch A: open circuit. The transmission control unit detected an open, meaning broken, circuit in sensor or switch "A" that reports whether the lever is in Park. Without this signal the control unit cannot be sure the gearbox is in Park. Where the sensor is and how it is built varies from make to make.
Can I keep driving with code P07B2 active?
With caution: limp mode possible, have it checked soon
Common causes — P07B2
Loose, corroded or water-damaged sensor connector Broken or damaged wiring Faulty position sensor or switch Sensor out of adjustment relative to the lever Worn or badly adjusted selector lever or linkage Fault in the transmission control unit
How do you fix code P07B2?
First check the sensor connector and wiring, and that the lever and its linkage are in the correct position. If the car will not start or the lever will not release, have a workshop look at it. Always apply the handbrake as well when parking.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P07B1 — Transmission friction element H stuck engaged
- Next code: P07B3 — Park position sensor/switch A: signal too low
Related codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0704 — Clutch switch input circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible