Skip to content
Fault code dictionary (DTC)

P07B3 — Park position sensor/switch A: signal too low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe transmission control unit is receiving a lower voltage than expected from Park position sensor or switch "A". This usually means a short to ground in the circuit or a faulty sensor. The exact value and the sensor's location depend on the make.
FamilyPowertrain (P)

Typical symptoms

Engine does not start, or starts in unusual lever positions
Wrong gear indication on the dashboard
Lever not releasing from Park
Odd reverse light behaviour
Transmission or engine warning light on
Gearbox in limp mode

Common causes

Pinched wiring or damaged insulation touching ground
Sensor connector with moisture or corrosion
Faulty position sensor or switch
Sensor out of adjustment relative to the lever
Worn selector lever or linkage
Fault in the transmission control unit

What to do

First check the sensor wiring and connector for moisture, corrosion or damaged wires. If the car will not start or the lever jams, go to a workshop. Always apply the handbrake as well when parked.

How to read code P07B3

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P07B3 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (B3) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P07B3 mean?

Park position sensor/switch A: signal too low. The transmission control unit is receiving a lower voltage than expected from Park position sensor or switch "A". This usually means a short to ground in the circuit or a faulty sensor. The exact value and the sensor's location depend on the make.

Can I keep driving with code P07B3 active?

With caution: limp mode possible, have it checked soon

Common causes — P07B3

Pinched wiring or damaged insulation touching ground Sensor connector with moisture or corrosion Faulty position sensor or switch Sensor out of adjustment relative to the lever Worn selector lever or linkage Fault in the transmission control unit

How do you fix code P07B3?

First check the sensor wiring and connector for moisture, corrosion or damaged wires. If the car will not start or the lever jams, go to a workshop. Always apply the handbrake as well when parked.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes